Hey Mike,
I'm not sure where to post this, just move it if it's not the right place here.
I switched my WM license to Android in May, right when Beta 1 was released.
Everything worked fine, but then I changed the ROM of my phone and did not think about Pleco for some time.
Now I installed it again and it just stays in demo-mode. I.E. HWR or the audio module.
So far I:
- Uninstalled Pleco, removed the old folder from my sc card.
- Downloaded the big add-on pack from the Beta 3 thread and copied it to my sd card.
- Installed Pleco again (fresh download).
- Entered my ID.
- Went to Settings -> General -> Reset All.
Didn't help.
Any ideas on that?
Mitch
(I'm using a HTC Desire with Gingervillain / Android 2.3.5)
I'm not sure where to post this, just move it if it's not the right place here.
I switched my WM license to Android in May, right when Beta 1 was released.
Everything worked fine, but then I changed the ROM of my phone and did not think about Pleco for some time.
Now I installed it again and it just stays in demo-mode. I.E. HWR or the audio module.
So far I:
- Uninstalled Pleco, removed the old folder from my sc card.
- Downloaded the big add-on pack from the Beta 3 thread and copied it to my sd card.
- Installed Pleco again (fresh download).
- Entered my ID.
- Went to Settings -> General -> Reset All.
Didn't help.
Any ideas on that?
Mitch
(I'm using a HTC Desire with Gingervillain / Android 2.3.5)