Hi Mike, sorry for the delay in getting back to you but I wanted to have a play first. I open the reader then select the text file I want to read and it comes up fine, if I then exit the reader and restart again (without doing anything else) it comes up blank. I can then select another text to read and it will show but if I exit and re-enter immediately it also comes up blank and if I exit select the first text and then re-enter reader the first text is also blank however I can then exit and select another (third) text and this one will show... if I close P2 and restart it works fine...
I have also noticed another quirk... when I am in P2 and I try to go into the character info section on the modules menu it does not bring up the stroke order info at all, unless I change the dictionary and then select the character... then it comes up and works as normal... I am sure this worked ok before... not sure what I have done there. I am using a Kaiser/TyTN II/Vario III though with both Touchflo and Cube so this may have something to do with it... I have put both P1 and P2 in the exclusions list on touchflo but it still doesnt like writing on the screen if there is a scroll bar present.
I have also noticed another quirk... when I am in P2 and I try to go into the character info section on the modules menu it does not bring up the stroke order info at all, unless I change the dictionary and then select the character... then it comes up and works as normal... I am sure this worked ok before... not sure what I have done there. I am using a Kaiser/TyTN II/Vario III though with both Touchflo and Cube so this may have something to do with it... I have put both P1 and P2 in the exclusions list on touchflo but it still doesnt like writing on the screen if there is a scroll bar present.